Front Anchor

FRONT ANCHOR

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, Occupant Classification System (OCS), seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to follow these instructions may result in accidental airbag deployment.

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.

NOTE: The following procedure is for replacement of an ineffective or damaged seat belt anchor buckle unit. The front seat belt anchor buckle also includes a seat belt tensioner. If the front seat belt anchor buckle is ineffective or damaged, but the seat belt anchor buckle tensioner is not deployed, review the recommended procedures for Handling Non-Deployed Supplemental Restraints. Service and Repair . If the seat belt anchor buckle tensioner has been deployed, review the recommended procedures for Service After A Supplemental Restraint Deployment before removing the unit from the vehicle. Service and Repair .





1. Position the front seat belt anchor buckle and tensioner unit (3) into the vehicle.
2. Install and tighten the screw (2) that secures the anchor buckle unit to the weld nut behind the inner sill (1). Tighten the screw to 45 Nm (33 ft. lbs.).
3. Reconnect the body wire harness connector (4) to the anchor buckle tensioner initiator.
4. Reinstall the quarter trim panel over the front seat belt lower anchor buckle and tensioner unit on the inner sill at the base of the B-pillar. Rear Quarter Trim Panel - Installation.





5. Engage the front seat belt anchor latch plate (1) into the anchor buckle (2).
6. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) Verification Test procedure should be performed following service of any SRS component. Service and Repair.