Low/Reverse Band

Low Reverse Band Adjustment

1. Clean all the dirt from the band adjusting screw area. Remove and discard the locknut.

2. Install a new locknut on the adjusting screw.

3. Tighten the adjusting screw using Band Adjusting Ratchet T71 P-77370-H and Socket T71 P-77370-D or equivalent. Tool T71 P-77370-H or equivalent, is a pre-set torque wrench which will click when the torque on the adjusting screw reaches 13.5 Nm (10 lb-ft).

4. Back off the adjusting screw exactly 3 turns.

5. Hold the adjusting screw from turning and tighten locknut to 54 Nm (40 lb-ft).