Audio Control Module (ACM)

Audio Control Module (ACM)













Removal

1. NOTE: Module configuration is only required when a new Audio Control Module (ACM) with single CD is being installed.

Upload the ACM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Information Bus. Programming and Relearning

2. NOTE: Use the special tools labeled N0.1 R for the right side and N0.1 L for the left side.

Using tool 4715-1 from the special tool kit, insert the special tools in the slots at all 4 corners of the ACM with the lettering facing up until a click is heard.

3. While pushing outward on all 4 special tools, pull the ACM out then disconnect the electrical connectors.

4. Remove the special tools from the ACM by pressing inward on the ACM retention tabs and then pulling the special tools out.

Installation

1. Press the ACM in until a click is heard from each of the 4 retention tabs.

2. Download the configuration information to the ACM. For additional information, refer to PMI in Information Bus. Programming and Relearning