Console - Floor

Console - Floor









Removal and Installation

Rear floor console section

1. Remove the LH and RH seats. For additional Information, refer to Seats.

2. Lift the park brake lever upward.

3. Place the selector lever in the NEUTRAL position.

4. Remove the 2 rear floor console section screw covers.

5. Remove the 2 rear floor console screws.

6. Remove the selector lever trim panel in the following sequence.

1. Lift the rear of the panel upward, releasing the rear retaining clips.

2. Pull the panel toward the rear of the vehicle releasing the front retaining clips.

7. Remove the 2 front-to-rear floor console screws.

8. Remove the rear section of the floor console in the following sequence.

1. Lift the rear section of the floor console upward and disconnect the electrical connectors.

2. Guide the park brake lever boot over the park brake handle.

3. NOTE: The power window switch electrical connectors are interchangeable with the switches; be sure to mark the connectors to make sure of proper installation.

Disconnect the electrical connectors, if equipped with power windows.

Front floor console section

9. Pull the lower sides of the front floor console outward releasing the 4 pin-type retainers.

10. NOTE: To aid in the installation, it may be necessary to rotate the controls to align the cables with the temperature control and mode control doors.

Detach the temperature control and mode control cables at the heater core and evaporator core housing.





11. Pull the front floor console section toward the rear of the vehicle, releasing the retaining clips from the instrument panel. Disconnect the 2 electrical connectors from the HVAC controller.





12. Remove the front floor console section.

13. To install, reverse the removal procedure.
- To install, make sure to align the retaining clips to the adjacent retaining clip holes.