Trim Panel: Service and Repair

1. Remove rear seats.
2. Remove coat hook screw and coat hook cover.
3. Remove front door scuff plate (13209) as outlined.
4. Remove front safety belt bezel. Remove front safety belt guide bolt from the B-pillar.
5. Remove front safety belt retaining bolt from front floor pan (11135).






6. Remove upper quarter trim panel (31012) by carefully prying off front edge of lower quarter trim panel then rear edge.
7. Remove rear safety belt from slot in quarter trim panel.
8. To remove lower quarter trim panel, remove three push pins at rear, one at bottom and one at top of quarter trim panel and pull rear of quarter trim panel out and forward.
9. Route front safety belt retractor and tongue (611 B08) through opening in front safety belt retractor and tongue.






10. Remove quarter trim panel from vehicle.






11. Remove quarter trim panel shield if necessary
12. To install, reverse Removal procedure. Tighten safety belt mounting bolts to 30-40 N.m (20-29 lb-ft).