Rear

Special Tools

Removal

CAUTION: If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water.

1. Remove the wheel and tire.





2. Detach the parking brake cable from the brake caliper.
1 Pull back the parking brake lever.
2 Disconnect the cable from the parking brake lever.
3 Remove the conduit retaining clip (if equipped).
4 Detach the cable and conduit from the brake caliper.





3. CAUTION: Suspend the brake caliper to prevent load being placed on the brake hose.

Detach the brake caliper from the anchor plate.





4. Remove the brake pads.





5. CAUTION: When the brake caliper piston is retracted into the piston housing, brake fluid will be displaced into the brake fluid reservoir.

Using the special tool, retract the brake caliper piston.

Installation

1. NOTE: Apply high temperature grease to the brake pad contact points.

To install, reverse the removal procedure.
2. Depress the brake pedal, check the fluid level in the brake fluid reservoir and top up if necessary with brake fluid.