Brake Fluid Reservoir

Removal





All Vehicles

1. CAUTION: If brake fluid is spilled on the paintwork, the affected are must be immediately washed down with cold water.

Disconnect the electrical connector from the filler cap.
1 Pull back the tab.
2 Depress the clips.
3 Disconnect the electrical connector.





2. CAUTION: Make sure the filler cap does not become contaminated.

Remove the brake fluid reservoir filler cap.





3. Using a suitable clean suction device drain the reservoir.
4. Install the brake fluid reservoir filler cap.





5. Detach the reservoir.





6. Detach the central electrical box screw.





7. Detach the electrical connector clip.





8. CAUTION: Cap the hose connections to prevent fluid loss or dirt contamination.

Disconnect the brake master cylinder feed hose.





Vehicles with manual transaxle

9. CAUTION: Cap the hose connections to prevent fluid loss or dirt contamination.

Disconnect the clutch master cylinder feed hose.





All Vehicles
10. Disconnect the brake fluid reservoir wiring harness.

Installation

1. NOTE: After installation, bleed the brake system.

To install, reverse the removal procedure.