Seat Belt Height Adjuster: Service and Repair

SAFETY BELT SHOULDER HEIGHT ADJUSTER

REMOVAL

4-door, 5-door and Wagon







1. Detach the safety belt lower anchor.

3-door







2. Detach the safety belt lower anchor.
1. Remove the Torx bolt from the anchor rail.
2. Slide the safety belt off the anchor rail.

All Vehicles







3. NOTE: Certain production trim panels have a retaining clip on the front edge.

Detach the B-pillar upper trim panel.
1. Detach the retaining clips.
2. Remove the lower anchor bolt and spacer from the safety belt webbing (4-door and Wagon shown).
3. Feed the safety belt webbing through the B-pillar upper trim panel.







4. Detach the upper safety belt anchor.







5. Remove the height adjuster.

INSTALLATION






















1. CAUTION:
- Make sure the spacer is correctly located between the floor covering and inner sill.
- Make sure the pin on the B-pillar trim is located correctly into the height adjuster.
- Make sure that the rear end of the anchor rail, on 3-door vehicles, is correctly located before tightening the Torx bolt.

To install, reverse the removal procedure.