Halfshaft Seal RH

Halfshaft Seal RH





Special Tool(s)





Material

Removal





1. Loosen the strut and spring assembly top mount nuts by five turns (left-hand side shown).
2. Raise and support the vehicle.





3. CAUTION: Protect the ball joint seal using a soft cloth to prevent damage.

Detach the lower arm ball joint from the wheel knuckle.
1. Remove the bolt
2. Detach the lower arm ball joint





4. Remove the intermediate shaft center bearing retaining nuts and cap.
- Discard the cap and nuts





5. CAUTION: Support the halfshaft. The inner joint must not bend more than 18 degrees. The outer joint must be bent more than 45 degrees.

Detach the intermediate shaft and halfshaft from the transaxle and secure it to one side.
- Allow the oil to drain into a suitable container.





6. Using the special tools, remove the halfshaft oil seal (left-hand side shown right-hand side similar).

Installation





1. Using the special tool, install the halfshaft oil seal.





2. CAUTION: Support the halfshaft. The inner joint must not bend more than 18 degrees. The outer joint must be bent more than 45 degrees.

Attach the intermediate shaft and halfshaft to the transaxle.





3. NOTE: Install a new intermediate shaft center bearing cap and nuts.

Install the intermediate shaft center bearing cap.





4. CAUTION: Protect the ball joint seal using a soft cloth to prevent damage.

Attach the lower arm ball joint to the wheel knuckle.





5. NOTE: The fill height is 5-10 mm below the lower edge of the filler hole.

Check the transaxle fluid level and top up with Manual transmission fluid if necessary.
6. Lower the vehicle.





7. Tighten the strut and spring assembly top mount nuts.