Wheel Studs - Disc

Wheel Studs - Disc Brakes








Removal

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. They must be replaced with the same part number, or an equivalent part, if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove the rear brake disc.

3. Using the special tool, remove the wheel stud.





Installation

1. Position the wheel stud in the flange, making sure the serrations on the stud line up with the serrations in the flange. Install the washers and a wheel nut.





2. CAUTION: Do not use power tools to install the wheel stud or damage to the flange may occur.

Tighten the wheel nut until the stud is seated against the hub flange.

3. Remove the wheel nut and the washers. Discard the wheel nut.

4. Install the brake disc.