Turbine Shaft Speed (TSS) Sensor

Turbine Shaft Speed (TSS) Sensor





Material

Removal
All engines
1. Remove the battery tray.





2.0L engine
2. Remove the air cleaner housing.
1. Disconnect the mass air flow (MAF) sensor electrical connector.
2. Disconnect the crankcase ventilation hose.
3. Disconnect the air cleaner outlet hose.
- Pull out the air cleaner housing from the rubber bushings.





2.3L engine
3. Remove the air cleaner assembly.
1. Disconnect the crankcase ventilation hose.
2. Disconnect the air cleaner outlet hose.
3. Remove the bolts and pull out the air cleaner resonator.

All engines





4. NOTE: The resonator is plugged into the bracket.

Remove the air cleaner intake hose with the resonator.





5. Disconnect the turbine shaft speed (TSS) sensor electrical connector.





6. Remove the TSS sensor.
- Check the TSS sensor bore.
- Check the O-ring seal for nicks or cuts and install a new O-ring if necessary.

Installation
All vehicles

1. NOTE: Apply a light coat of petroleum jelly to the O-ring seal before installation.

NOTE: Apply thread sealer to the bolt.

To install, reverse the removal procedure.

Vehicles with front and rear power windows
2. Initialize the door window motors.