Installation

Special Tool(s)

Part 1:

Part 2:

Material

Installation

1. NOTE: Install a new intermediate shaft center bearing cap and locknuts.

NOTE: Install a new halfshaft snap ring.

To install, reverse the removal procedure.
- Check and, if necessary, fill the transmission with the specified fluid. The total fill capacity is 4.0 pints (1.9L). Apply sealant to the fill plug threads and install the fill plug.
- Fill the power steering system.
- Fill the brake fluid reservoir to the specified level. Bleed the clutch hydraulic system.
- Adjust the gearshift cables.