Sensor, Rear

Sensor - Rear

Removal
1. Remove the rear passenger seat.





2. Disconnect the rear anti-lock brake sensor electrical connector.
3. Raise and support the vehicle.





4. Remove the rear anti-lock brake sensor harness from the floor pan.





5. Remove the anti-lock brake sensor harness bracket bolt.

6. NOTE: The sensor may be seized to the axle. Use Rust Penetrant and Inhibitor F2AZ-19A501-A meeting Ford specification ESR-M99C56-A to loosen the sensor for removal.





Remove the rear anti-lock brake sensor.
1 Remove the rear anti-lock brake sensor bolt.
2 Remove the rear anti-lock brake sensor.

Installation

1. NOTE: Be sure to apply High Temperature Nickel Anti-Seize Lubricant F6AZ-9L494-AA meeting Ford specification ESE-M124A-A to the sensor body where it will make contact when installed.





To install, reverse the removal procedure.