General Specifications

General Specifications

Part 1 Of 7:

Part 2 Of 7:

Part 3 Of 7:

Part 4 Of 7:

Part 5 Of 7:

Part 6 Of 7:

Part 8 Of 7:

a Newly Installed-Refers to the condition of the "NEW" drive belt before the engine has made no more than one rotation and before the belt has had a chance to stretch or seat into the pulley grooves.
c P = Primary, S = Secondary, E = Exhaust
d Time necessary for plunger to leak down 1.6 mm of travel with 222 N force and leak down fluid in tappet.
e Distance front edge of bearing is installed below front face of cylinder block.
f 0.050 Undersize-add 0.025 to standard thickness.
g Pin bore and crank bearing bore must be parallel and in same vertical plane within the specified total difference when measured at the ends of a 203 mm bar, 101.5 mm on each side of rod centerline.
h Cylinder Bore Diameter Red-90.200-90.213 Blue-90.213-90.226 Yellow-90.226-90.239
i Measured at 42 mm from piston dome, at 90 degrees to the piston pin.
j Piston pin outer diameter is larger than piston pin bore, providing a possible interference fit.
k Specification in 90.200 mm diameter gauge.
l With installation of a new filter.