Shifter A/T: Service and Repair

Removal





1. Remove the shifter top control panel.





2. Disconnect the electrical connectors.





3. Remove the shifter bezel.





4. Remove the bulb from the bezel.





5. Disconnect the TCS connector.





6. CAUTION: Extra force may be needed to lift up on the handle. Do not to pull too far or damage to the overdrive cancel button may result, as the wires may be pulled out of the switch.

Remove the screw and the handle.
7. Raise and support the vehicle.





8. Disconnect the shift cable and discard the plastic clip.
9. Lower the vehicle.





10. Remove the shifter.

Installation





1. NOTE: It is necessary to install a new plastic clip prior to installation.

To install, reverse the removal procedure.