Transmission Removal

REMOVAL

1. Disconnect the battery ground cable.





2. Remove the gearshift lever knob.





3. Remove the console panel gearshift plate. Lift the gearshift lever boot over the gearshift lever.





4. Remove the bolts and the shift lever.
5. With the vehicle in NEUTRAL, raise and support the vehicle.
6. Remove the dual converter H-pipe.





7. CAUTION: Index-mark the driveshaft flange and pinion flange, and the driveshaft slip yoke and transmission output shaft.

Remove the driveshaft.





8. Disconnect the reversing lamp switch electrical connector. Disconnect the wiring harness from the transmission.
9. Remove the starter motor.





10. Remove the bolts.





11. Remove the starter solenoid nuts and position the wires aside.
12. Remove the starter motor.





13. Disconnect the OSS sensor electrical connector. Disconnect the wiring harness from the transmission.





14. Remove the bolt and the clutch release lever cover.





15. CAUTION: To prevent component damage, do not depress the clutch pedal with the transmission removed.

Disengage the clutch release cable from the clutch release fork.





16. Remove the clutch cable retainer and remove the clutch cable from the transmission.





17. If transmission disassembly is necessary, drain the transmission fluid.





18. Position a transmission jack and support the transmission.





19. Remove the bolts and the transmission crossmember.





20. Remove the bolts.





21. Lower the transmission and remove the five bolts.