Evaporative System Service Port: Service and Repair

EVAPORATIVE EMISSION TEST PORT

REMOVAL







1. Disconnect the pin-type retainer.
2. Raise and support the vehicle.
3. Remove the RH front wheel.







4. Remove the RH front splash shield.
1 Remove the three screws.
2 Remove the five pin-type retainers.







5. Remove the evaporative emission test port by disconnecting at the EVAP canister purge outlet tube junction.

INSTALLATION
1. To install, reverse the removal procedure.
- Leak test the system. Evaporative Emission System Leak Test
- Carry out the evaporative emission repair verification drive cycle. Evaporative Emission Repair Verification Drive Cycle