Reactivation
ReactivationWARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, and notes at the beginning of the deactivation procedure.
1. Disconnect the battery ground cable and wait at least one minute.
2. Remove the restraint system diagnostic tool from the passenger air bag module electrical connector.
3. Connect the passenger air bag module electrical connector.
4. Install the right hand A/C register duct.
^ Connect the A/C duct at the air plenum.
^ Install the duct at the A/C register and install the two screws.
5. Close the glove compartment.
6. Remove the restraint system diagnostic tool from the clockspring electrical connector.
7. Connect the clockspring electrical connector at the base of the steering column.
8. Install the steering column opening lower reinforcement.
1 Position the steering column opening lower reinforcement.
2 Install the bolts.
9. Install the steering column opening lower finish panel.
1 Align the steering column opening lower finish panel and push in, seating the retaining clips.
2 Install the screws.
10. Connect the battery ground cable.
11. WARNING: The restraint system diagnostic tool is for restraint system service only. Remove from vehicle prior to road use. Failure to remove could result in injury and possible violation of vehicle safety standards.
With all the restraint system diagnostic tools removed, prove out the Supplemental Restraint System (SRS).