Instrument Panel Center Finish Panel

INSTRUMENT PANEL CENTER FINISH PANEL







Removal and Installation
1. Disconnect the battery ground cable.
2. Apply the parking brake.
3. If equipped with a floor selector lever, position the selector lever in the 1 position.
4. Remove the integrated control panel (ICP).
5. Remove the 2 bolts and instrument panel lower steering column cover.
- To install, tighten to 9 Nm (80 lb-in)

6. Remove the ashtray.

7. NOTE: When installing the instrument panel center finish panel, be sure the alignment tabs are positioned correctly.

Remove the 7 screws and remove the instrument panel center finish panel.
- Disconnect the electrical connector by reaching through the ICP opening.

8. To install, reverse the removal procedure.