Instrument Cluster (IC)

INSTRUMENT CLUSTER (IC)







Removal
1. If installing a new instrument cluster (IC), upload the instrument cluster (IC) configuration information to the scan tool.
2. Lower the steering column to the lowest position.

3. NOTE: Pull the instrument cluster (IC) finish panel out to release the fasteners.

Remove the 2 screws and the instrument cluster (IC) finish panel.

4. Remove the 4 screws and the instrument cluster (IC).
- Disconnect the electrical connector.

Installation
1. Position the instrument cluster (IC) in the instrument panel.
- Connect the electrical connector.

2. Install the 4 instrument cluster (IC) screws.
3. Install the instrument cluster (IC) finish panel and the 2 screws.
4. If installing a new instrument cluster (IC), download the instrument cluster (IC) configuration information from the scan tool into the new instrument cluster (IC).

5. NOTE: If a new instrument cluster (IC) is installed, the instrument cluster (IC) and the PCM require a parameter reset to allow the instrument cluster (IC) and the PCM to recognize each other. Failure to carry out the parameter reset to the instrument cluster (IC) and the PCM may result in a no start condition.

If installing a new instrument cluster (IC), carry out the parameter reset procedure.

6. If installing a new instrument cluster (IC), carry out the key programming procedure.