Safety Belt Retractor - Rear, Center

SAFETY BELT RETRACTOR - REAR, CENTER







Removal and Installation

WARNING: After any crash, all of the following safety belt assemblies and attaching hardware must be inspected by an authorized dealer to verify correct function:
- Retractors
- Buckles
- Belt tension sensor (BTS) (if equipped)
- Front safety belt buckle support assemblies (slide bar) (if equipped)
- Safety belt shoulder belt height adjusters (if equipped)
- Child safety seat tether bracket assemblies
- Automatic locking retractor (ALR) feature for child safety seats (passenger seating positions only)

If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the Diagnosis and Testing portion, a new safety belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet metal must be restored to its original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety belt assemblies and attaching hardware may increase the risk of serious personal injury or death in a crash.

After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems increases the risk of serious personal injury or death in a crash.

NOTE: The rear center safety belt retractor is equipped with a cinch tongue and does not have automatic locking retractor (ALR) mode. For information about cinch tongue operation, refer to Safety Belt System.

1. From under the front of the rear cushion assembly, push each of the 2 seat cushion release tabs in, lift up at the front and remove the rear cushion assembly.
2. Remove the bolt and safety belt anchor.
- To install, tighten to 55 Nm (41 lb-ft).

3. Remove the parcel shelf.

4. NOTE: The anti-rotation tab must be correctly aligned for correct installation.

Remove the nut and rear center safety belt retractor.
- To install, tighten to 40 Nm (30 lb-ft).

5. NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants prior to installation.

To install, reverse the removal procedure.

6. Check the active restraint system for correct operation.