Transmission Filler Tube

Transmission Filler Tube

Material

Material:

Transmission Fluid Filler Tube - Partial Zero Emissions Vehicle (PZEV) (Part 1):

Transmission Fluid Filler Tube - Partial Zero Emissions Vehicle (PZEV) (Part 2):

Transmission Fluid Filler Tube - Non-Partial Zero Emissions Vehicle (PZEV) (Part 1):

Transmission Fluid Filler Tube - Non-Partial Zero Emissions Vehicle (PZEV) (Part 2):

Removal

All vehicles

1. NOTE: Partial zero emissions vehicle (PZEV) shown, non-PZEV similar.

Disconnect the mass air flow (MAF) sensor electrical connector.





2. NOTE: Non-PZEV shown, PZEV similar.

Disconnect the crankcase ventilation hose and disconnect the brake booster vacuum hose.





Partial zero emissions vehicle (PZEV)

3. Loosen the air cleaner inlet hose clamp.





Non-PZEV

4. Remove the 2 bolts.





All vehicles

5. Loosen the clamp, pull the air cleaner assembly straight up and remove the air cleaner assembly.





6. Remove the transmission fluid filler tube bolt.





7. Disconnect the throttle control electrical connector.





8. Disconnect the bottom PCM electrical connector.





9. Remove the transmission fluid level indicator.





10. Remove the power steering hose retainers and the wiring harness retainer from the transmission fluid filler tube.





11. Remove the transmission fluid filler tube bolt, rotate the transmission fluid filler tube from under the throttle body and remove the transmission fluid filler tube.





Installation

All vehicles

1. Inspect the transmission fluid filler tube O-ring for damage before installing the transmission fluid filler tube. If the transmission fluid filler tube O-ring is damaged, install a new transmission fluid filler tube O-ring. Lubricate the transmission fluid filler tube O-ring with clean transmission fluid.





2. Install the transmission fluid filler tube.
^ Tighten to 8 Nm (71 inch lbs.).





3. Install the power steering hose retainers and the wiring harness retainer on the transmission fluid filler tube.





4. Install the transmission fluid level indicator.





5. Connect the bottom PCM electrical connector.





6. Connect the throttle control electrical connector.





7. Install the transmission fluid filler tube bolt.
^ Tighten to 8 Nm (71 inch lbs.).





8. Position the air cleaner in place and tighten the air cleaner outlet pipe clamp.
^ Tighten to 4 Nm (35 inch lbs.).





9. NOTE: PZEV shown, non-PZEV similar.

Connect the crankcase ventilation hose and connect the brake booster vacuum hose.





PZEV

10. Tighten the air cleaner inlet hose clamp.
^ Tighten to 4 Nm (35 inch lbs.).





Non-PZEV

11. Install the 2 bolts.
^ Tighten to 9 Nm (80 inch lbs.).





All vehicles

12. NOTE: PZEV shown, non-PZEV similar.

Connect the MAF sensor electrical connector.