Brake Caliper Anchor Plate, Front

Brake Caliper Anchor Plate - 4.0L SOHC and 4.6L (3V)

Disc Brake System - Exploded View 4.0L SOHC And 4.6L (3V) (Part 1):

Disc Brake System - Exploded View 4.0L SOHC And 4.6L (3V) (Part 2):

Removal and Installation
1. Remove the brake pads.

2. NOTE: Clean any residual Threadlock(R) compound from the anchor plate threads before installing the bolts.

Remove and discard the 2 anchor plate bolts and remove the brake caliper anchor plate.
^ To install, tighten new anchor plate bolts to 115 Nm (85 lb-ft).
3. Inspect the brake caliper anchor plate assembly.
^ Check the guide pins and boots for binding and damage.
^ Replace worn or damaged pins. Lubricate the pins with the specified grease.
^ Install a new brake caliper anchor plate if it is worn or damaged.
4. To install, reverse the removal procedure.