Brake Caliper Support Bracket, Rear

Brake Caliper Support Bracket

Disc Brake System - Exploded View (Part 1):

Disc Brake System - Exploded View (Part 2):

Removal and Installation
1. Remove the rear axle shaft.
2. Remove the 3 bolts and the brake disc shield.
^ To install, tighten to 20 Nm (15 lb-ft).

3. NOTE: Make sure the anti-moan bracket holes, the brake caliper support bracket and the brake caliper anchor plate holes line up during installation.

Remove the anti-moan bracket.
^ To install, tighten to 35 Nm (26 lb-ft).
4. Remove the 4 brake caliper support bracket nuts, bolts and the bracket.
^ To install, tighten to 68 Nm (50 lb-ft).
5. To install, reverse the removal procedure.