Compressor Manifold and Tube Assembly

COMPRESSOR MANIFOLD AND TUBE ASSEMBLY







Removal and Installation

NOTE: Installation of a new suction accumulator is not required when repairing the A/C system, except when there is physical evidence of contamination from a failed A/C compressor or damage to the suction accumulator.

1. Recover the refrigerant.
2. Loosen the compressor manifold bolt and detach the compressor manifold.
- Discard the O-ring seals.
- To install, tighten to 21 Nm (15 lb-ft).

3. Remove the compressor manifold and tube bracket nut.
- To install, tighten to 25 Nm (18 lb-ft).

4. Disconnect the pressure transducer electrical connector.
5. Disconnect the suction accumulator outlet fitting.
- Discard the O-ring seals.

6. Remove the condenser inlet fitting nut and disconnect the fitting.
- Discard the O-ring seal.
- To install, tighten to 8 Nm (71 lb-in).

7. To install, reverse the removal procedure.
- Install new O-ring seals.
- Lubricate the refrigerant system with the correct amount of clean PAG oil.

8. Evacuate, leak test and charge the refrigerant system.