Flywheel: Service and Repair

Flywheel

Lower End Components - Exploded View, Flexplate, Flywheel and Crankshaft Rear Seal:

Removal
1. Remove the clutch.
2. Remove the 8 bolts and the flywheel.

Installation

1. NOTE: Special bolts are used for flywheel installation. Do not use standard bolts.

Position the flywheel. Install the 8 bolts and tighten in the sequence shown in 3 stages.
^ Stage 1: Tighten to 13 Nm (10 lb-ft).
^ Stage 2: Tighten to 50 Nm (37 lb-ft).
^ Stage 3: Tighten an additional 90 degrees.





2. Install the clutch.