TR3650 Manual Transaxle/Transmission

Transmission

Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Remove the catalytic converter H-pipe.
4. Remove the driveshaft.
5. Remove the 3 starter motor bolts and position the starter motor aside.





6. Remove the 4 subframe cross brace nuts and the subframe cross brace.





7. Disconnect the reverse lamp switch electrical connector. Disconnect the wiring harness from the transmission.





8. Disconnect the output shaft speed (OSS) sensor electrical connector. Disconnect the wiring harness from the transmission.





9. If transmission disassembly is necessary, drain the transmission fluid.





10. Position a transmission jack and support the transmission.





11. Remove the transmission crossmember.
1 Remove the crossmember-to-transmission bolt.
2 Remove the 4 crossmember-to-frame bolts and the transmission crossmember.





12. Lower the transmission 25.4 mm (1 inch). Disconnect the shift linkage from the transmission.





13. Release the clutch hydraulic tube clip and separate the connector from the clutch slave cylinder.
14. Remove the 2 spacer plate bolts.
15. Remove the 7 transmission-to-engine bolts.
16. Pull the transmission rearward until the input shaft is clear of the pressure plate, then lower the transmission from the vehicle.