40 Percent

SEAT BACKREST COVER - SECOND ROW, 40 PERCENT

Exploded View

Taurus X Rear Seat Backrest, Second Row, 40 Percent:

Taurus X Rear Seat Cushion, Second Row, Manual 40 Percent (Part 1):

Taurus X Rear Seat Cushion, Second Row, Manual 40 Percent (Part 2):

Taurus X Rear Seat Cushion, Second Row, Power-Fold 40 Percent (Part 1):

Taurus X Rear Seat Cushion, Second Row, Power-Fold 40 Percent (Part 2):

Taurus X Rear Seat Backrest, Second Row, 60 Percent:

Taurus X Rear Seat Cushion, Second Row, 60 Percent (Part 1):

Taurus X Rear Seat Cushion, Second Row, 60 Percent (Part 2):

Removal and Installation
1. Remove the head restraint.
2. With the backrest folded down, release the backrest trim cover lower J-clip.
3. Separate and remove the outer pivot cover.
4. Release the 2 backrest trim cover inside J-clips to hard back panel.
5. If equipped, disconnect the backrest heater mat electrical connector and route through the backrest trim cover.

6. CAUTION: Use care when separating the seat backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip may be torn from the seat backrest foam.

Release the hook-and-loop strips, invert the backrest trim cover and remove the 3 rows of hog rings.

7. Release the hook-and-loop strips and invert the backrest trim cover to the top of the backrest.

8. NOTE: The head restraint guides are not interchangeable.

Lift the backrest foam pad, squeeze the tabs in and remove the 2 head restraint guides.

9. Remove the backrest trim cover.
10. To install, reverse the removal procedure.