60 Percent

SEAT CUSHION - SECOND ROW, 60 PERCENT

Disassembly and Assembly

Part 1:

Part 2:

1. Remove the 60 percent rear seat.

2. CAUTION: When installing the backrest frame, make sure to follow the torque sequence or damage to the components may occur.

Remove the rear seat backrest.

3. Remove 2 screws, pull and remove the riser RH inner cover.
4. Remove 3 screws and the riser RH outer cover.
5. Remove 2 screws, pull and remove the riser LH inner cover.
6. Remove 3 screws and the riser LH outer cover.
7. Remove the screw and the recliner handle.
8. Remove 2 screws and the LH recliner outer cover.
- On assembly, make sure the release strap is through the cover opening.

9. Remove the pin-type retainer, release the locator pins and remove the LH recliner inner cover.

10. WARNING: Use care when the seat back frame is removed and when releasing the recliners from a backrest upright position. The recliners are spring-loaded, which may cause the recliner upper arms to fold with significant speed/force. Failure to follow this instruction may result in serious personal injury.

NOTE: Note cable routing for installation.

Remove the 3 cables from the LH recliner and route them out of the seat cushion frame.







11. Remove the 2 bolts and the LH recliner.
- To install, tighten to 50 Nm (37 lb-ft).

12. Remove the 3 outboard cushion frame-to-riser nuts.
- To install, tighten to 23 Nm (17 lb-ft).

13. Remove the cushion frame-to-riser bolt in front of the RH recliner.
- To install, tighten to 50 Nm (37 lb-ft).

14. Remove the cushion frame yoke-to-riser bolt.
- To install, tighten to 50 Nm (37 lb-ft).

15. Remove the 3 RH recliner-to-riser bolts and separate the cushion frame from the riser.
- To install, tighten to 50 Nm (37 lb-ft).

16. Remove the 2 bolts, route out the cable and remove the LH latch foot.
- To install, tighten to 50 Nm (37 lb-ft).

17. Remove the 2 bolts, route out the cable and remove the RH latch foot.
- To install, tighten to 50 Nm (37 lb-ft).

18. Remove the bolt and the safety belt buckle.
- To install, tighten to 37 Nm (27 lb-ft).

19. Remove the screw and the inner pivot cover.
20. Remove the pivot grommet.
21. Remove the screw and the stationary foot cover.
22. Remove the pin-type retainer, screw and the RH recliner cover.

23. NOTE: Note cable routing for installation.

Remove the cushion frame yoke-to-RH recliner bolt, route out the cable and remove the RH recliner.
- To install, tighten to 50 Nm (37 lb-ft).

24. Remove the cushion trim cover from the cushion foam pad.

25. CAUTION: When installing the backrest frame, make sure to follow the torque sequence or damage to the components may occur.

To assemble, reverse the disassembly procedure.