Seat - Rear, Second Row
SEAT - REAR, SECOND ROW60/40 Percent Seats:
Power-Fold 40 Percent Seat:
Removal
Power-fold seat
1. Disconnect the power-fold seat electrical connector.
40 percent and 60 percent seat
2. Fold the affected 40 percent or 60 percent seat up to the E-Z entry position.
3. Remove the 2 riser/seat track-to-floor pan bolts and 2 riser/seat track-to-floor pan nuts for the 40 percent or 60 percent seat.
- To install, tighten to 48 Nm (35 lb-ft).
4. Remove the affected seat.
Inboard seat strikers
5. Remove the 2 screws and the console bracket cover.
6. Remove the 2 bolts and the inboard seat striker.
- To install, tighten to 80 Nm (59 lb-ft).
Outboard seat strikers
7. Remove the 2 bolts and the outboard striker.
- To install, tighten to 48 Nm (35 lb-ft).
Installation
Outboard seat strikers
1. Position the outboard seat striker to the floor and install the 2 bolts.
- Tighten to 48 Nm (35 lb-ft).
Inboard seat strikers
2. Position the inboard seat striker to the floor and install the 2 bolts.
- Tighten to 80 Nm (59 lb-ft).
3. Position the console bracket cover and install the 2 screws.
RH 40 percent seat
4. Position the seat in the vehicle and install the retainers in the following sequence.
1 Install the riser/seat track-to-floor pan rear inboard nut.
- Tighten to 48 Nm (35 lb-ft).
2 Install the riser/seat track-to-floor pan rear outboard nut.
- Tighten to 48 Nm (35 lb-ft).
3 Install the riser/seat track-to-floor pan front outboard bolt.
- Tighten to 48 Nm (35 lb-ft).
4 Install the riser/seat track-to-floor pan front inboard bolt.
- Tighten to 48 Nm (35 lb-ft).
LH 40 percent and 60 percent seats
5. Position the seat in the vehicle and install the retainers in the following sequence.
1 Install the riser/seat track-to-floor pan rear inboard nut.
- Tighten to 48 Nm (35 lb-ft).
2 Install the riser/seat track-to-floor pan rear outboard nut.
- Tighten to 48 Nm (35 lb-ft).
3 Install the riser/seat track-to-floor pan front outboard bolt.
- Tighten to 48 Nm (35 lb-ft).
4 Install the riser/seat track-to-floor pan front inboard bolt.
- Tighten to 48 Nm (35 lb-ft).
Power-fold seat
6. Connect the electrical connector.
All seats
7. Check the seat for correct operation.
- With the seat in the upright position, both latch feet must lock to the strikers.
- When releasing the seat to the E-Z entry position, the latches must release freely and not bind to the strikers.
- Make sure the safety belts and buckles are accessible to the occupants after installation.