Instrument Cluster (IC)

Instrument Cluster (IC)









Removal

1. If installing a new Instrument Cluster (IC), upload the IC configuration information to the scan tool.

2. Lower the steering column to the lowest position.

3. NOTE: Pull the IC finish panel out to release the fasteners.

Remove the 2 screws and the IC finish panel.

4. Remove the 4 screws and the IC.
- Disconnect the electrical connector.

Installation

1. Position the IC in the instrument panel.
- Connect the electrical connector.

2. Install the 4 IC screws.

3. Install the IC finish panel and the 2 screws.

4. If installing a new IC, download the IC configuration information from the scan tool into the new IC. For additional information, refer to PMI in Information Bus. Programming and Relearning

5. NOTE: If a new IC is installed, the IC and the PCM require a parameter reset to allow the IC and the PCM to recognize each other. Failure to carry out the parameter reset to the IC and the PCM may result in a no start condition.

If installing a new IC, carry out the parameter reset procedure. Passive Anti-Theft System (PATS)

6. If installing a new IC, carry out the key programming procedure.