Condenser to Evaporator Line

Condenser to Evaporator Line













Removal and Installation

1. Recover the refrigerant.

2. With the vehicle in NEUTRAL, position it on a hoist.

3. Disconnect the evaporator inlet line fitting.
- Discard the O-ring seal.

4. Detach the condenser-to-evaporator line clip.

5. Remove the condenser outlet fitting nut and disconnect the fitting.
- Discard the O-ring seal.

- To install, tighten to 8 Nm (71 lb-in).

6. Remove the condenser-to-evaporator line.

7. To install, reverse the removal procedure.
- Install new O-ring seals.

- Lubricate the refrigerant system with the correct amount of clean PAG oil.

8. Evacuate, leak test and charge the refrigerant system.