Safety Belt Retractor - Second Row, Outboard

Safety Belt Retractor - Second Row, Outboard, Taurus X

NOTE: LH shown, RH similar.










Removal and Installation

WARNING: After any crash, all of the following safety belt assemblies and attaching hardware must be inspected by an authorized dealer to verify correct function:
- Retractors
- Buckles
- Belt tension sensor (BTS) (if equipped)
- Front safety belt buckle support assemblies (slide bar) (if equipped)
- Safety belt shoulder belt height adjusters (if equipped)
- Child safety seat tether bracket assemblies
- Automatic locking retractor (ALR) feature for child safety seats (passenger seating positions only)
If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the Diagnosis and Testing portion, a new safety belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet metal must be restored to its original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety belt assemblies and attaching hardware may increase the risk of serious personal injury or death in a crash.

After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems increases the risk of serious personal injury or death in a crash.

NOTE: Vehicle with auxiliary climate control shown, vehicle without auxiliary climate control similar.

All retractors

1. Remove the rear quarter trim panel.

2. Remove the safety belt retractor D-ring bolt.
- To install, tighten to 48 Nm (35 lb-ft).

Vehicles with auxiliary climate control

3. From beneath the vehicle on the LH side, remove the 2 auxiliary climate control floor pan bracket nuts.
- To install, tighten to 6 Nm (53 lb-in).





4. Remove the 2 auxiliary climate control duct pin-type retainers and detach the auxiliary climate control ducts.

5. Remove the 3 auxiliary climate control housing bolts.
- To install, tighten to 6 Nm (53 lb-in).

6. NOTICE: Use extreme caution when handling the auxiliary climate control unit to prevent damage to the refrigerant lines.

Carefully position aside the auxiliary A/C unit.

All retractors

7. Remove the bolt and safety belt retractor.
- To install, tighten to 48 Nm (35 lb-ft).

8. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

To install, reverse the removal procedure.

9. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test procedure in Safety Belt System Component Tests and General Diagnostics.