Roll Restrictor

Roll Restrictor

Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. NOTE: The bolts are different lengths, mark the bolts for installation.

Remove the roll restrictor bolts and the roll restrictor.





Installation

1. NOTE: The bolts are different lengths, make sure the bolts are in the correct location using the marks made during removal.

Install the roll restrictor and the roll restrictor bolts.

1. Tighten the roll restrictor bolt to 70 Nm (52 lb-ft).

2. Tighten the roll restrictor-to-transaxle bracket bolt to 48 Nm (35 lb-ft).