Door Glass Top Run - Rear

Door Glass Top Run - Rear





Removal and Installation

1. Remove the rear door speaker. For additional information, refer to Information and Entertainment Systems Door Speaker.

2. NOTE: Do not touch the adhesive surface during removal or installation of the watershield, as re-bonding will be impaired. If additional adhesive is required during installation, apply seam sealer as necessary to completely seal the watershield to the inner door.

Remove the watershield.

3. Temporarily install the window control switch or the window regulator handle to raise or lower the window to align the regulator clamp with the access hole.

4. Push out the pin and then push out the sleeve of the 2-part spacer.

5. Supporting the glass, lower the glass and regulator to the lowest position.

6. Remove the door glass top run.





7. To install, reverse the removal procedure.