Transaxle Rear Support Insulator

Transaxle Rear Support Insulator









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

2. Remove the roll restrictor bolt at the subframe.
- To install, tighten to 70 Nm (52 lb-ft).

3. Remove the roll restrictor bolt from the transaxle bracket.
- To install, tighten to 70 Nm (52 lb-ft).

4. Remove the roll restrictor.

5. To install, reverse the removal procedure.