Universal Serial Bus (USB) Cable and Port

Universal Serial Bus (USB) Cable and Port

WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.

Exploded View

Instrument Panel Routing










Center Console Routing










Removal

NOTE: Removal steps in this procedure may contain installation details.

NOTE: The USB (Universal Serial Bus) cables are part of the vehicle wiring harness. Because the cables cannot be removed from the harness, this procedure applies to the replacement of the cables only.

1. NOTE: Steps 1 thru 16 apply for access to the instrument panel USB (Universal Serial Bus) cable only.

Vehicles with manual transmission.





2. Vehicles with automatic transmission.





3.





4.





5. Cubby Box front floor console.





6. Closed Bin front floor console.





7. Cubby Box front floor console.





8. Cubby Box front floor console.
- 2 Nm (18 lb-in)





9. Closed Bin front floor console.
- 2 Nm (18 lb-in)





10.





11. Closed Bin front floor console.





12. Cubby Box front floor console.





13. NOTE: Closed bin console shown, all others similar.






14.






- 1 Nm (9 lb-in)

15. Depending on option content. Remove the FCDIM (Front Control/Display Interface Module) or the FDIM (Front Display Interface Module). REFER to Front Control Display Interface Module (FCDIM) or REFER to Front Display Interface Module (FDIM)

16. NOTE: FDIM (Front Display Interface Module) shown FCDIM (Front Control/Display Interface Module) similar.






17. NOTE: Steps 17 thru 19 apply for access to the center floor console USB (Universal Serial Bus) cable only.

Remove the center front floor console. REFER to Console - Front, Floor .

18.





19.





Installation

NOTE: The USB (Universal Serial Bus) cables are part of the vehicle wiring harness. Because the cables cannot be removed from the harness, this procedure applies to the replacement of the cables only.

1. To install, reverse the removal procedure.

2. Overlay the new USB (Universal Serial Bus) cable on the vehicle wiring harness, following the routing of the original cable. REFER to Exploded View for cable routing.