Sunroof / Moonroof Panel: Service and Repair

Roof Opening Panel Glass


WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.

Exploded View










Removal

NOTE: The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel system or whenever:
- the roof opening panel motor has been removed from the roof opening panel system
- the roof opening panel glass has been removed from the roof opening panel system
- the roof opening panel assembly has been removed from the vehicle
- a new roof opening panel motor has been installed
- a new sliding glass panel has been installed
- a new roof opening panel assembly has been installed

REFER to Roof Opening Panel Motor Initialization Programming and Relearning.

NOTE: Removal steps in this procedure may contain installation details.

1. Open the roof opening panel to the VENT position.

2. Remove the 4 roof opening panel glass retainers (2 on each side).

- 4 Nm (35 lb-in)






3. From the outside of the vehicle, remove the roof opening panel glass assembly.

Installation

1. To install, reverse the removal procedure.

- Check for correct roof opening panel alignment. REFER to Roof Opening Panel Alignment .

2. Initialize the roof opening panel motor. REFER to Roof Opening Panel Motor Initialization Programming and Relearning.