Sunroof / Moonroof Track: Service and Repair
Trough Assembly
WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.
Exploded View
Removal
NOTE: The roof opening panel motor must be initialized when repairs are carried out on any part of the roof opening panel system or whenever:
- the roof opening panel motor has been removed from the roof opening panel system
- the roof opening panel glass has been removed from the roof opening panel system
- the roof opening panel assembly has been removed from the vehicle
- a new roof opening panel motor has been installed
- a new sliding glass panel has been installed
- a new roof opening panel assembly has been installed
REFER to Roof Opening Panel Motor Initialization Programming and Relearning.
NOTE: Removal steps in this procedure may contain installation details.
1. Remove the roof opening panel glass. REFER to Roof Opening Panel Glass .
2. NOTE: RH (Right Hand) side shown, LH (Left Hand) similar.
Disconnect both trough assembly arms from the roof opening panel frame and position up.
3. Press down on center of the trough assembly and shift the trough assembly to one side and lift up to disconnect the RH (Right Hand) guide clip from the roof opening panel track assembly. Repeat for the LH (Left Hand) side guide clip.
4. Remove the trough assembly through the roof panel opening.
Installation
1. To install, reverse the removal procedure.