Brake Caliper Anchor Plate

Brake Caliper Anchor Plate

WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.

Material(s)






Exploded View










Removal

NOTE: Removal steps in this procedure may contain installation instructions.

1. Remove the wheel and tire. REFER to Wheel and Tire .

2. Remove the brake caliper spring.





3. NOTICE: Do not pry in the caliper sight hole to retract the pistons as this can damage the pistons and boots.

NOTICE: Do not allow the brake caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.

Remove the 2 brake caliper guide pin covers, the 2 brake caliper guide pin bolts and position the brake caliper aside.
- To install, tighten to 28 Nm (21 lb-ft).





4. Remove the outboard brake pad.





5. Remove the 2 brake caliper anchor plate bolts and the brake caliper anchor plate.
- To install, tighten to 175 Nm (129 lb-ft).





Installation

1. Apply the specified grease to the brake caliper anchor plate as shown.










2. To install, reverse the removal procedure.

- Apply brakes several times to verify correct brake operation.