Safety Belt Retractor - 2nd Row, Center

Safety Belt Retractor - 2nd Row, Center

WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.

Removal

WARNING: After any crash, all of the following safety belt assemblies and attaching hardware must be inspected by an authorized dealer to verify correct function:
- Retractors
- Buckles
- Front safety belt buckle support assemblies (slide bar) (if equipped)
- Safety belt shoulder belt height adjusters (if equipped)
- Child safety seat tether bracket assemblies
- ALR (Automatic Locking Retractor) feature for child safety seats (passenger seating positions only)

If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the Component Tests of this system, a new safety belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted, the sheet metal must be restored to its original structural integrity and new safety belt assembly and attaching hardware must be installed. Failure to install new safety belt assemblies and attaching hardware may increase the risk of serious personal injury or death in a crash.

1. If equipped with a 60/40 split cushion.

2. If equipped with a full seat cushion, remove the rear seat cushion. REFER to Seat Cushion - Full Bench .

3. NOTE: Note the position of the component before removal.

NOTE: Make sure that the component is installed to the position noted before removal.

NOTE: Install all the bolts finger tight before final tightening.
Visual check
- 55 Nm (41 lb-ft)

4. NOTICE: If the safety belt webbing retracts further than the safety belt webbing stop, a new safety belt retractor must be installed.

8. NOTE: Touching the adhesive surface will impair rebonding.
48 Nm (35 lb-ft)

Installation

1. To install, reverse the removal procedure.