Engine Mount: Service and Repair

Engine Mount

Engine Mount (View 1 of 3)










Engine Mount (View 2 of 3)










Engine Mount (View 3 of 3)









Removal and Installation

1. NOTICE: Failure to position the wood block and floor jack as illustrated can result in damage to the oil pan.

Position a floor jack with a block of wood under the front of the oil pan.






2. Remove the A/C tube retaining clamp bolt.
- To install, tighten to 8 Nm (71 lb-in).


3. Remove the 2 A/C tube retaining clamp bolts.
- To install, tighten to 10 Nm (89 lb-in).


4. Detach the wiring harness retainer from the degas bottle.

5. Remove the nut, bolt and position the engine coolant degas bottle aside.
- To install, tighten to 9 Nm (80 lb-in).


6. Detach the power steering hose retainer from the engine mount brace.

7. Remove the bolt and the ground wire from the engine mount brace.
- To install, tighten to 10 Nm (89 lb-in).


8. Remove the 3 bolts and the engine mount brace.
- To install, tighten to 25 Nm (18 lb-ft).


9. Remove the 4 engine mount-to-engine nuts.
- To install, tighten in the sequence shown to 70 Nm (52 lb-ft).






10. Remove the 2 engine mount spacers.

11. Using the floor jack, lower the engine 25 mm (1 in).

12. NOTE: It is necessary to reposition the A/C tubes to remove the engine mount.
Remove the nut, the 2 bolts and the engine mount.

- To install, tighten the bolts to 55 Nm (41 lb-ft) and the nut to 63 Nm (46 lb-ft).


13. To install, reverse the removal procedure.