Safety Belt Retractor and Pretensioner
Safety Belt Retractor and Pretensioner
Removal
1. WARNING: Before beginning any service procedure, Failure to follow this instruction may result in serious personal injury.
Refer to: Health and Safety Precautions (100-00 General Information, Description and Operation).
2.
1. Part of 54611B08 RH/54611B09 LH (D-ring bolt)
Torque: 35 Nm
2. Part of 54611B08 RH/54611B09 LH (Webbing guide)
3. Part of 14014 (Adaptive load limiter electrical connector (RH side only))
4. Part of 14014 (Safety belt retractor pretensioner electrical connector)
5. 54611B08 RH/54611B09 LH (Safety belt retractor and pretensioner)
6. W709066 (Safety belt retractor and pretensioner bolt)
Torque: 35 Nm
7. Part of 54611B08 RH/54611B09 LH (Spacer)
8. Part of 54611B08 RH/54611B09 LH (Safety belt anchor bolt)
Torque: 47.5 Nm
9. Part of 54611B08 (Belt Tension Sensor (BTS) electrical connector)
10. Part of 14014 (Belt Tension Sensor (BTS) electrical connector (RH side only)
3. WARNING: Turn the ignition OFF and wait one minute to deplete the backup power supply. Ignition must remain OFF until repair is complete. Failure to follow this instruction may result in serious personal injury or death in the event of an accidental deployment.
If a SRS fault is present, continue to step 4. Otherwise, turn the ignition OFF, wait at least one minute and continue to step 5.
4. NOTE: The air bag warning indicator illuminates when the correct RCM fuse is removed and the ignition is on.
Depower the SRS.
Refer to: Supplemental Restraint System (SRS) Depowering and Repowering (501-20B Supplemental Restraint System, General Procedures).
5. Remove the B-pillar trim panel.
Refer to: B-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
6. Remove the bolt and separate the D-ring.
7. Turn the top of the webbing guide, slide it down and detach it from the B-pillar.
8. Remove the bolt and the safety belt retractor and pretensioner.
9. Disconnect the pretensioner and adaptive load limiter (RH side only) electrical connectors.
Installation
1. Connect the pretensioner and adaptive load limiter (RH side only) electrical connectors.
2. Position the safety belt retractor and pretensioner and install the bolt.
Torque: 35 Nm
3. Position the D-ring and install the bolt.
Torque: 35 Nm
4. Attach the webbing guide to the B-pillar.
5. Install the B-pillar trim panel.
Refer to: B-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
6. If the SRS was depowered, repower the SRS.
Refer to: Supplemental Restraint System (SRS) Depowering and Repowering (501-20B Supplemental Restraint System, General Procedures).
7. Check the active restraint system for correct operation.
Refer to: Airbag Supplemental Restraint System (SRS) (501-20B Supplemental Restraint System, Diagnosis and Testing).