Assembly

FLANGE

1. If idle mixture adjusting screw was removed, install screw temporarily.
2. Install TPS unit onto bracket assembly.
3. Install mixture bypass solenoid valve and gasket.
4. Ensure components move freely.

CARBURETOR BODY

1. Assemble each jet in their proper locations.
2. Install accelerator pump filter as follows:
a. Insert check ball.
b. Insert filter assembly.
c. Insert snap ring so that damage is not done to the pump bore assembly.
3. Install slow cut solenoid valve and gasket.
4. Install diaphragm chamber and gasket.

BODY TO FLANGE

1. Place a new gasket on top of flange, then position body on top.
2. Install flange screws and wire bracket. Tighten attaching bolt.
3. Connect diaphragm chamber rod and secondary valve shaft and E-clip.
4. Install throttle return and 2nd lock springs.
5. Insert accelerating pump return spring into pump bore. Install piston from the top.

AIR HORN

1. Install air vent solenoid valve and gasket.
2. Install choke breaker diaphragm unit and hose.
3. Connect rod to choke breaker diaphragm unit and secure with E-clip.
4. Install feedback solenoid valve as follows:
a. Pass wires through air horn and insert vertically while holding the valve body. It must not be inserted while bending.
b. Tighten attaching bolt.
5. Install needle valve seat, then needle valve onto seat assembly.
6. Install new gasket onto air horn.
7. Install float and secure with float pin.

AIR HORN TO BODY

1. Carefully assemble air horn and body assembly.

NOTE: DO NOT bump float against body when installing air horn to the body. Ensure wires are not pinched between air horn and body.

2. After assembly, ensure to accurately insert the grooves of the accelerating pump piston rod and boot.
3. Install screws to secure air horn onto body assembly.
4. Connect link to the choke cam lever, then install E-clip.
5. Install pump arm assembly.
6. Arrange each wire as follows:
a. Arrange wires of slow cut solenoid valve on inner side and arrange the wire of the auto choke heater onto outer side so that wires DO NOT interfere with throttle return spring operation.
b. Install wire pins on to their positions in connector assembly.
7. Ensure each part of carburetor operates freely.