Instruments - Broken, Loose Or Missing Switch Knobs
Group Ref.: Chassis/Body ElectricalBulletin No.: 338310
Date: December, 1993
SUBJECT:
LOOSE/MISSING VP CLUSTER SWITCH KNOBS (REPLACE KNOBS)
MODELS:
1989-91 GEO METRO
CONDITION:
Some owners may experience breakage of knobs on some instrument panel switches.
CORRECTION:
Replacement switch knob kits have been released for the above application to allow service of the switch knobs independently from the switch assemblies. Switch knobs should be replaced using an approved adhesive using procedures listed below:
1. Use a chloroprene rubber bonding agent such as GM P/N (U.S. 12345097 and Canada 12345532) or equivalent adhesive meeting specification MMM-A-1671A type.
2. Apply a thin coat of adhesive to both surfaces of the knob and switch slider as show in Illustration.
NOTE:
Be careful not to apply an excessive amount of adhesive.
3. Let dry 1 to 2 minutes.
4. Carefully assemble the knob to the switch slider and check for proper operation of the switch assembly.
96067618 Kit, Knob - I/P Interior Lamp Switch
96067619 Kit, Knob - WSW and WSWA Switch
PART AVAILABILITY:
Parts are currently available from GMSPO.
WARRANTY INFORMATION:
Labor Operation:
N1980, IP Interior Lamp SW Knobs
- Replace
N3505, WSW and WSWA SW Knobs
- Replace
Labor Time: Use Published Labor Operation Time