Service Procedure

FIGURE 1:

BE CERTAIN TO PERFORM THIS PROCEDURE ON BOTH SIDES OF VEHICLE.

1. Remove the rear side sill scuff plate. It is not necessary to remove rear seat or center pillar inner lower trim piece. See Figure # 1.

FIGURE 2:

2. Lift carpet in area of drain plug. Location of the drain plug is approximately 15 inches forward of the rear wheels and six inches inboard. See Figure # 2.

FIGURE 3:

FIGURE 4:

NOTICE: On driver's side of vehicle, it may be necessary to move the wiring harness out of the way to access the drain plug. See Figures 3 & 4 for views of plug locations on both sides of vehicle.

3. If drain plug is in its seat, determine with finger pressure if it is loose. If it is loose, reseat it firmly.

If drain plug is not in its seat, locate it and reseat it firmly in its proper position.


4. Reinstall carpet and rear side sill scuff plate.

5. Install Campaign Identification Label.