Power Mirror Motor: Service and Repair

Power Mirror Actuator Replacement

Removal

1. Remove the mirror holder Mirror Holder Replacement.

2. Remove the power mirror Power Mirror Replacement, and disconnect the power mirror 6P connector from the door wire harness.

3. Record the power mirror 6P connector (A) terminal locations and wire colors.





4. Disassemble the power mirror 6P connector, and remove all terminals (B) from the connector.

5. Remove the screw and the gasket (C).

6. Remove the screw and the harness clip (D).

7. Remove the cover (A).





8. Remove the three screws, and separate the mirror housing (B) from the bracket (C).

9. Remove the screws and the actuator (A).






Installation

1. Route the wire harness (A) of a new actuator through the hole in the bracket (B) and gasket (C).





2. Install the parts in the reverse order of removal.

3. Insert the new actuator terminals into the connector in the original arrangement.





4. Apply tape to seal the intersection of the wire harness and the gasket.

5. Reassemble in the reverse order of disassembly.

NOTE: Be careful not to break the mirror when reinstalling it to the actuator.

6. Reinstall the mirror assembly on the door.

7. Operate the power mirror to ensure smooth operation.