Steering Angle Sensor: Service and Repair

Steering Angle Sensor Replacement

SRS components are located in this area. Review the SRS component locations Locations, and the precautions and procedures Service and Repair before doing repairs or service

NOTE: Do not damage or drop the combination switch assembly/cable reel as the steering angle sensor is sensitive to shock and vibration.

1. With the wheels in the straight-ahead position and the steering wheel centered, remove the steering wheel.

2. Remove the steering column covers Service and Repair and the cable reel Service and Repair.

3. Remove the combination switch assembly Steering Column Removal/Installation.

4. Remove the combination light switch (A) and the wiper/washer switch (B) from the combination switch body assembly (C).





5. Install the combination switch body assembly in the reverse order of removal, and note these items:

NOTE:

- Do not remove the steering angle sensor from the combination switch body assembly.
- Set the turn signal canceling sleeve (D) position so that the arrow mark (E) points straight up.
- Note that the tightening order is specified for the combination switch assembly/cable reel mounting screws Steering Column Removal/Installation.