A/T Countershaft Reverse Selector Hub And 3rd Gear Installation

A/T Countershaft Reverse Selector Hub and 3rd Gear Installation

Special Tools Required

- Driver Handle, 40 mm I.D. 07746-0030100

1. Install 2nd gear, 1st gear, 5th gear, and the 37 x 41 x 54.3 mm collar on the countershaft.

2. Slide 3rd gear (A) over the countershaft, and press it in place using the driver (40 mm I.D.) and a press.





3. Install the 31 mm cotters, the 35 x 47 x 7.8 mm collar, the set ring, the needle bearing, and 4th gear.

4. Slide the reverse selector hub (A) over the countershaft, then press it in place using the driver (40 mm I.D.) and the press.

NOTE: Some reverse selector hubs are not press-fitted and can be installed without using the driver (40 mm I.D.) and a press.