Intermediate Shaft Installation

Intermediate Shaft Installation

1. Clean the areas where the intermediate shaft (A) contact the differential thoroughly with solvent, and dry them with compressed air.

NOTE: Do not wash the rubber parts with solvent.





2. Insert the intermediate shaft into differential correctly.

NOTE: Hold the intermediate shaft horizontally to prevent damaging the oil seal (B).

3. Install the flange bolt (A) and two dowel bolts (B), then install a new set ring (C).





4. Install the front right driveshaft Front Driveshaft Installation.

5. Refill the transmission with the recommended transmission fluid ATF Replacement.

6. Check the wheel alignment, and adjust it if necessary Service and Repair.

7. Test-drive the vehicle.